Finishing for the wood veneered panel.
Finishing is the last step in a series of processes to make product from wood (veneer). The process of finishing to the veneer panels is very similar to the finishing process for solid wood panels. The stain and coating used and the finishing looked for the veneer panel are very much the same with the finishing for the solid wood panel. But however, the wood veneer and solid wood are different material, so there may be some differences properties between both of them that have to be considered in the finishing process
- The finishing color.
Although the wood veneered panel can be finished in any color, but the transparent color finish is the most proper color. The panel is layered with wood veneer since we want to get the wood looked and the wood characters at the panel, then the finish should also enhance the beauty of the wood looked of the veneer. The transparent finish is absolutely needed when the special exotic veneer is used and when the veneer is arranged in the special form and pattern. For the panel with special inlay veneer then even the dark stain should be avoid since it may block and kill the special effect of the veneer setting. A transparent finish with light stain or without stain application and the good quality clear coat is the most recommended finish for the inlay veneer.
finishing for inlay veneer
The solid color or opaque color will totally kill the beauty and the special looked for the veneer. If the light paint is used to make a semi-transparent paint then we may still be able to see the pattern of grain and pores of the wood. It still can be used to finish for some veneered panel. But if the full closed solid color finish is needed, then we better use m.d.f. or particle board as the substrates. The m.d.f. and particle surface which has no pores and grain can be easier finished to make solid color.
The wood veneer is sometime has different color base, pore and pattern with the solid wood. The veneer usually is made from the older and more straight trees. The veneer tends to have bigger and deeper pore and grain. If the close pores finish is needed, then we may need to apply the filler to fill the wood veneer pores and grain.
- The sanding process.
If the veneer has special arrangement, the sanding will be more complicated. The sanding machine is absolutely needed to sand the special inlay veneer. The wide belt sander or stroke sander is very good machine to handle this job. If the big machine is not available, then the hand sander machine can be used to take care the wood veneered panel
If the finishing process requires physical distress, then we need to consider the thickness of the veneer layer. Some of physical distress such as: nails, rocking or chaining can be performed without any problems, but the distress with deep wounds cannot be held. The gouges distress with chisel, or sanded trough distress can peel of the veneer layer form the damage to the veneer. For the big and deep distress we better uses the veneer with thick layer or solid wood panel.